Spektrum DX6i Manuel d'instructions Page 25
- Page / 26
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
25SPEKTRUM DX6i • RADIO INSTRUCTION MANUAL
EN
Throttle Stick Ratchet Strip Installation
1. Carefully remove and keep 6 screws and open transmitter
case.
2. Remove and keep 2 screws from existing ratchet strip.
3. Do not remove grease from plastic part under strip.
Note: Air Ratchet Strip (SPM9007) (A) with center bump is
for use with airplanes (ACRO). See illustrations.
4. Attach strip to gimbal using 2 screws.
5. Turn screws to get desired stick tension.
6. Carefully close transmitter case using 6 screws.
CAUTION: Make sure no wires or components are
pinched or damaged while installing back cover.
APPENDIX
Control Stick Length Adjustment
1. Adjust control stick length using a 1.5mm Allen wrench.
2. Turn the setscrew in the stick counterclockwise to loosen it.
Make stick shorter by turning it clockwise or longer by turn-
ing it counterclockwise.
3. After adjustment of stick length, tighten setscrew.
Control Stick Tension Adjustment
1. Remove batteries from transmitter.
2. Remove 6 screws from transmitter back cover using a #1
Phillips screwdriver.
3. Carefully remove transmitter’s back cover. Do not damage
internal components.
4. Adjust tension screw in brass bushing on end of ratchet strip
(counterclockwise to loosen, clockwise to tighten) using a #0
Phillips screwdriver See illustrations below.
5. Adjust tension screw for rudder, aileron or elevator gimbal
springs (counterclockwise to loosen, clockwise to tighten)
using a #0 Phillips screwdriver See illustrations below.
6. Install transmitter back cover using 6 screws.
CAUTION: Make sure no wires or components are
pinched or damaged while installing back cover.
A
Tighten
Loosen
Turn these
screws to
adjust control
stick tension.
- Instruction Manual 1
- Bedienungsanleitung 1
- Manuel d’utilisation 1
- Manuale di istruzioni 1
- WARRANTY REGISTRATION 2
- GENERAL NOTES 2
- PILOT SAFETY 2
- TABLE OF CONTENTS 3
- TRANSMITTER FUNCTIONS 5
- 1. 2. 3 6
- HOLD SWITCH WHILE POWERING ON 7
- USING TRANSMITTER 8
- SETUP LIST 9
- Activate 10
- THRO CUT 11
- WINGTAILMIX 12
- RANGE CHECK 13
- COPY/RESET 14
- TRAVEL ADJ 15
- PITC CUR 16
- SWASH MIX 17
- REVO MIX 18
- FAILSAFE 19
- Servo Installation 20
- Servo Precautions 20
- Power System Requirements 20
- TROUBLESHOOTING GUIDE 21
- FCC INFORMATION 22
- FAA INFORMATION 22
- PARTS LIST 22
- WARRANTY AND REPAIR POLICY 23
- PARTS CONTACT INFORMATION 24
- APPENDIX 25
- RECOMMENDED SERVO CONNECTIONS 26
ATON Telefone Benutzerhandbücher
Beginnend mit C
Commentaires sur ces manuels