Spektrum SPM3130 DX3S Manual Manuel d'utilisateur télécharger pdf (Page 17)

17SPEKTRUM DX3S USER GUIDE

7. With the steering wheel, throttle trigger and Aux

channel (if applicable) in the desired preset failsafe

positions, press the Rolling Selector to initiate the

bind process and to store the failsafe positions. BIND

will flash for a few seconds then stop, indicating the

process is complete. The LED on the receiver should

now be solid, indicating a successful bind has taken

place.

8. Remove the bind plug and store it in a convenient

place.

To return to the main screen press and hold the Rolling

Selector for more than three seconds.

Note: The only time it is necessary to do a

rebind is when different failsafe positions are

desired, e.g. when throttle or steering reversing

has been changed, or if the receiver is to be

bound to a different model memory.

Note: Some Spektrum receivers, like the

SR3000, use a bind button rather than a bind

plug. The binding process is the same with

this receiver, however, instead of inserting the

plug before powering up the receiver, press

and hold the bind button while powering up

the receiver to enter bind mode.

FAILSAFE

Failsafe positions are also set during binding. In the

unlikely event that the radio link is lost during use, the

receiver will drive the servos to their preprogrammed

failsafe positions (normally full brakes and straight

steering). If the receiver is turned on prior to turning on

the transmitter, the receiver will enter the fail-safe mode,

driving the servos to their preset failsafe positions. When

the transmitter is turned on, normal control is resumed.

Failsafe servo positions are set during binding (see Bind

on the previous page).

THROTTLE PUNCH

The Throttle Punch function is used to offset the throttle

to a preprogrammed position and activated when 4%

throttle travel is applied. Throttle punch is typically

used in nitro vehicles to reduce the lag due to throttle

linkage slack.

TO ACCESS THE THROTTLE PUNCH

FUNCTION

In the List screen use the Rolling Selector to highlight the

Th Punch function.

Press the Rolling Selector to access the Throttle Punch

function. The above screen will appear.

Use the Rolling Selector and place a box around Th

Punch. Press the Rolling Selector and the surrounding

boxwillflash;thenrotatetheRollingSelectortoadjust

the value of the throttle punch position and press the

Rolling Selector.

Note: Throttle punch will remain active until

the value is reset to zero.

To return to the main screen press and hold the Rolling

Selector for more than three seconds.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Spektrum SPM3130 DX3S Manual Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle Spektrum SPM3130 DX3S Manual